Multifunctional module (kitchen/ bath/ WC/ closet)

Multifunctional module (kitchen/ bath/ WC/ closet), installed behind the driver´s seat.
This module is inserted into the vehicle and bolted in the existent fixing points. (e.g. rail system, fixing points of the seats etc.)
Equipment:
Model 1 – Kitchen:
Lower drawer prepared for compressor cool box, 31 l, 12 – 220 Volts;
Center drawer with integrated (removable) gas cooker, automatic lightning with gas cartridges (no gas examination necessary);
Upper drawer with bowl, sink, 16 l water tank,
Module attachment (removable) with mirror and shelf.
Model 2 – Bath:
Lower drawer with BI-POT-toilet 13 l,
Storage drawer,
above: drawer with bowl, sink, 16 l water tank
at the top: attachment (removable) with mirror and shelf
Model 3 - WC
lower drawer with toilet
Model 4 – Closet:
Large storage drawer,
above: 2 small storage drawers,
Module attachment (removable) with mirror and shelf.
Dimensions:
B 40 cm, D 58,5 cm, H 120 cm (without attachment 78 cm).
Standard decors: blue-corrugated, silver grey and aluminium-corrugated.
Extra decors on enquiry.

Our module tower is only ONE module of a whole module run that transforms your van/minivan into a fully-equipped camper (cooking, washing, sleeping, stowing…). After your holidays you switch it back into your everyday vehicle. (Installation or removal of the modules only take a few minutes)
Under certain premises it is even possible to register your van as a special vehicle, as a camper.

The multifunctional tower leaves enough space for a bed with a length of 190 cm, also with a short wheelbase (e.g. rear board+sleeping bench or our selfstanding sleeping board)

Our alternative to the multifunctional tower are our kitchens and rear boards and/or selfstanding, foldable sleeping boards (with aluminium rail system) on which our sleeping mattresses lie on.

To the multifunctional tower as kitchen or bath model we offer a showering as well as a broiling top. Even a selfstanding rear tent or shading systems show the variety of our products. Just expect a fully-equipped van.

The module is inserted into the vehicle and installed in the according fixing points. (rail system, fixing points of the seats, tie-down rings etc.)
It is not necessary to modify anything in your van.
All our other modules as well as accessories can be adapted and removed without leaving any tracks behind.

Energy via cigarette lighter. No further extra equipment necessary.